Re: Length Of Bolts For Roloff 3 Pc Weights in reply to KCTractors, 11-16-2017 18:39:02
I have those weights on my tractor but can't tell you the length of the bolts. I would think you could do a bit of arithmetic and figure out the length. Thickness of weights + wheel center + width of loop + nut + washer = bolt length. I always use a grade 8 washer against the wedges because have seel several wedges cracked or broken in half. When you put them on get them good and snug then take the tractir out fora half hour ride. Then tighten them again. After working it for a week or two tighten them again. Also, there is about a 1/4" gap between the rim and weight that gets filled with mud and dirt. That mud, dirt holds moisture. I've seen a couple sets of rims that were rotted out and ruined so I blow that gap clean with a pressure washer a couple of times a year.
Re: Length Of Bolts For Roloff 3 Pc Weights in reply to KCTractors, 11-16-2017 18:39:02
Do you have the wedges? Del Huebner just sold a set of rolloff on the other site. Go there and in the ad section email him. I'm sure he will know the lenght.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
Latest Ad:
Wanted front suit case weights and rear wheel weights for a 1456 international.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
