Had it with the Holly carb, gave in and bought a Zenith carbuorator to replace. Imagine the Zenith will need to be fiddled with from factory. Any diagram or suggestions on how to set being different from Holly. Also, forgot which way turning the distributor advances the timing? Thanks.
Re: 73 4000 Carb in reply to Jeff Mans, 12-04-2016 10:00:05
Fwiw, on our 3000's Zenith, I tried it, then pulled it off & raised the float level a smidge. But this is on a high-hour/low on compression engine. Been running like a champ for at least 7-8 yrs, haven't had to touch it since then. Don't remember about distributor, put electronic unit on at same time & haven't touched it, either.
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Hiniker 1300 rear window frame looking for one closer to Iowa the better
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.