Re: Foed 2910 in reply to Farmer8n, 10-23-2016 10:15:44
According to the parts site the 2910 would have had either a synchro or non-synchro 8 speed when new. The earlier 6 speed transmissions that were available on the 3 cylinder thousand series and x600 series would bolt right up the the 2910 engine, so the transmission might have been swapped at some point. I'm not sure if a transmission swap to a 6 speed would require a swap out off the rear end as well though, so it may have had the entire rear half swapped out. Probably best to get the date codes off of the transmission, rear axle and hydraulic top cover, and compare them to the sticker under the hood.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
Looking for two coulters and mounting brackets for a JI Case centennial plow
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
