Re: Ford 501 Sickle mower in reply to Dan Chambers, 04-05-1999 11:09:38
I bought one for $275 that was repainted and had new blades. If you buy it the first thing I'd do is put on new blades. Also you can only use it with a Ford 2n, 8n, 9n, and up through the early 4000's because of the mounting hardware. Hope this helps.
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
16x38 (Double-Bevel) rear rims. In very good condition no welds or cracks.some surface rust, valve stem holes are perfect Asking 525 for the pair. (Or Best Offer) Pictures upon request.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.