(800) 853-2651
SHOP NOW

Touch Control Lever Stop Cam ????????

R

RICK IN GA

Member
Spent a lot of time going through the archives on this hydraulic adjustment procedure. Have not done it yet but need to now before I put my hydraulics back in the 881-D. I have read the Alternate procedure in the manuals and it says to "move the touch control lever against the cam stop in the raised position." In looking at my parts manuals it shows that the cam stop (930) only goes from 53/56. So I checked my 3 available 01 Series and none of them have the cam. My 54 NAA does have the cam. So here's the question.....How far do I move the touch control lever?????
a183113.jpg

a183114.jpg
 
You must log in or register to reply here.

Similar threads

Josh M.
Ford 3000 draft control
Replies
9
Views
607
wp6529
W
H
  • Question
Case 1370 Hydraulic remote control lever hard to move under pressure.
Replies
3
Views
390
KDR12
K
C
Select-O-Speed Parts
Replies
5
Views
523
Craig Myers
C
D
Ford 4000 PTO Wont Engage
Replies
10
Views
555
Dwilshire
D
C
800 hydraulic pump confusion....problem?
Replies
4
Views
412
Centerline
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top