I picked a coil from Bobcat today. $54.94 plus a 50 mile trip. Took the old coil with me, dead on replacement. New one has two wires old one has only one. When I took the valve out of the TW35 I noticed the coil was shorter than the new one. Evidently Ford changed the stem that the coil goes on from the early models to the late ones. This Bobcat coil would not work on it. I had an old valve assembly from a TW25. I took the stem out of it and put it in the TW35 valve. It is shifting as it should. Now, what coil fits the later valves? It looks like it is made onto the stem. Gonna try to take it apart later. Bobcat part # is 6671025. Thanks!!
Re: Dual Power Coil Update in reply to RodInNS, 04-22-2014 21:46:08
Here is the # off 1 coil: 60 6670 12VDC 462. This is the 1 that matches the Bobcat#. Dimensions are :1-1/2"tall, 1-1/8" diameter, 1/2" hole in center. Other coil has no numbers. Dimensions are: 1-1/8"tall. 1-1/8" diameter, can't measure hole in center. This coil looks to made on to the plumger. Wish I could post a picture.
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.