Springs for carb. For TO20

My carb. has missing or damaged springs, so I need pictures on how they are setup and where I can get the right springs. This is for all springs, including springs for the governor.
 
Ulysses,

On the carb there are three springs, 1 on the choke plate flapper and one on the choke rod. The third is a cmpression spring on the Fine adj. needle.
Both of choke springs are included in better carb re-build kits. (the one at TSC is pretty complete and ~$24.00) Steiner's complete carb kit for $45.00 has these springs also. The basic kit on this site has the needle adj spring but not the other two. The comprehensive kit shows the two choke springs but not the needle spring.

Send me an e-mail I have the gov. linkage springs. (2).



Jeff
Steriner kit
 

Not those springs, the kind that connects to various parts, then connects to somewhere on the engine or the body to hold the flappers or valves at the position set by the levers. I hope I explained it well.
 
Ulysses, There are two springs. One is on the verticle section of the govener shaft and the othe gose from the throttle rod to the water neck. If you send me an e-mail I can send you the page from the parts book.

Jeff
TEFerguson at AOL dot com
 
Here is a picture I took this morning of the two springs on the Gov. and throttle rod.

Jeff
a18536.jpg
 
(quoted from post at 09:55:48 07/08/10) Here is a picture I took this morning of the two springs on the Gov. and throttle rod.

Jeff
a18536.jpg

Yes, the spring near your alt/gen is missing on mine. Also, is there a pix of your carb.? I am missing springs on those as well.

One more thing, I tried to email to you, but it came back undelivered for some reason.

Ulysses
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top