(800) 853-2651
SHOP NOW

Ted clutch build

G

Gareth7603

New User
Hi I'm in the process of re doing all my transmission on my 1950 ted and had to take of the clutch pedal
So I lost the setting how much gap should there be between the the release bearing fork before it starts to push the release bearing its self or how do you go about setting the pedal on the shaft, I have a manual but it isent very clear thank in advance for anyone that can help
 

Clutch pedal free play is 3/8ths of an inch . Use a twist drill as a gauge . Losen the clamp hold the shaft end with a spanner and turn until the gap is correct . Tighten well .
 
mvphoto46455.jpg


mvphoto46456.jpg


Here I am adjusting the pedal on my 1957 FE35 Grey and Gold but the procedure is the same on the TEF TED and TEA.
 
You must log in or register to reply here.

Similar threads

J
2010D clutch install
Replies
0
Views
465
HoyeTractor-HT
H
M
Massey Ferguson 203 Workbull Industrial, need clutch replacement parts help.
Replies
11
Views
422
Stan Coryell
S
F
Ford 821 Clutch Problem
Replies
6
Views
360
Sean in PA
S
C
Belarus 25A1
Replies
4
Views
159
Trkr
T
R
Super C clutch pilot bearing
Replies
7
Views
326
Roger46
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top