ScottsTO30
New User
Hey guys.
So in the last few days I have replaced my axle seals, shimmed the axles correctly (phew!), and put in new brake pads and cleaned the whole area up.
With the tractor on jack stands, I adjusted the brake adjuster so I felt some resistance from the new pads when I spun each wheel by hand and then backed it off a few clicks (4 I think) until the wheel spun freely.
When I spun the wheels (again, by hand), and pushed on the master brake pedal, the wheels stop. When I push the independent pedals, each wheel stops. When I remove the jack stands, start her up, and go for a drive, I have no brakes (however hard I push on ANY pedal)??
What adjustment or issue am I missing here?
Sorry if this has been covered before, and if so, please point me to the thread I cannot find when I search.
Thank you.
Scott.
So in the last few days I have replaced my axle seals, shimmed the axles correctly (phew!), and put in new brake pads and cleaned the whole area up.
With the tractor on jack stands, I adjusted the brake adjuster so I felt some resistance from the new pads when I spun each wheel by hand and then backed it off a few clicks (4 I think) until the wheel spun freely.
When I spun the wheels (again, by hand), and pushed on the master brake pedal, the wheels stop. When I push the independent pedals, each wheel stops. When I remove the jack stands, start her up, and go for a drive, I have no brakes (however hard I push on ANY pedal)??
What adjustment or issue am I missing here?
Sorry if this has been covered before, and if so, please point me to the thread I cannot find when I search.
Thank you.
Scott.