(800) 853-2651
SHOP NOW

Next phase of C153 in Super C project

R

Rex Simpkins

Member
OK now that I have the back end of the engine in
place, I see alot of opinions on the front of the
engine and the cooling system. Can anyone tell me
how or if there is a way to use the original
radiator?
I understand how the 140 radiator and fan along
with top and lower radiator necks work work I was
just hoping I would not have to buy a radiator.

Also how did you go about making the cuts in the
engine front for the steering bolster?
 
I think there may be a few more challenges to put the C-153 in a regular "C" but I do not think it would be much different. I think the regular "C" is about an 1" shorter ( grill and fuel tank, radiator) but there have been some comments on here by fellows who have done it.

I have the parts together and I will arrange them on the shop floor on top of cardboard with the part# and original tractor they came from next to the part. So this should help anyone in the future who wants to do the same steps.It ain't been cheap but it should be a good neat project.
 
You must log in or register to reply here.

Similar threads

S
Farmall Super M Dimensions & Measurements
Replies
2
Views
234
ScaleModelDesign
S
C
Tractor project in March - Super C
Replies
3
Views
356
NY 986
N
M
Super C pedestal repair
Replies
8
Views
381
BarnyardEngineering
BarnyardEngineering
T
How do I drain the radiator and engine block?
Replies
6
Views
529
caterpillar guy
C
P
International 424 Hydraulics Questions
Replies
16
Views
1K
Peat
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top