C Hydraulic tank and lift on BN

Brad Motheral · Sep 5, 2012

Has anyone done it? what did you use for mounting holes? are the 2 fuel tank support holes in the right spot?
or do you need the flat sided C torque tube?

CNKS · Sep 5, 2012

You need a C or Super A torque tube and an engine with a place for the pump below the distributer/mag. Also the touch control levers. Local CaseIH dealer has one on the floor with the wrong color scheme.

uncle henry · Sep 5, 2012

i would go with a c front half because you can still use cultivators with it if you wanted to

gene bender · Sep 6, 2012

I have one someone built you also need to use the C gas tank for mounting and the sediment bowl placement. They built a batt box and welded the steering post to the lid so they could use the hy controls from the C. They did a fine job and had a disc plow from a SA mounted. I use it with a blade on the back and made brackets for Allis Chalmers planting units for sweetcorn using the rockshaft for lifting the planters. They kept the Bs lite sw assy.

mkirsch · Sep 6, 2012

You need to change so many parts, that you may as well get a whole other tractor.

You need a different engine block with the hydraulic pump.
You need a different torque tube with the flat mounting surface.
You need a different gas tank with the sediment bowl in the right place.

gene bender · Sep 13, 2012

You will alos need to get an extension made for the steering shaft to clear the hy pump.

gene bender · Sep 13, 2012

The Cs steering assy has the steering shaft coming out the wrong side for the B

C Hydraulic tank and lift on BN

Brad Motheral

Member

CNKS

Well-known Member

uncle henry

Member

gene bender

Well-known Member

mkirsch

Well-known Member

gene bender

Well-known Member

gene bender

Well-known Member

Similar threads