Looking for a Farmall H sleeve puller or puck

Yooper Farmall · Oct 13, 2010

Picked up a '41 dual fuel H, brought the head to a machine shop and had the hardened seats installed, decided to put in the high compression pistons and now need to locate a sleeve puller, any suggestions?

tractorsam · Oct 13, 2010

Any local machine shop can make one for you. Alternatively an engine rebuilder might have a tool to pull them cheaply.

If you're good with a welder then you can carefully weld several (3-4) beads of weld vertically in the sleeve and it'll shrink enough to push out easily.

Hope that helps, Sam

El Toro · Oct 13, 2010

Get your machine/metal shop to make a puck. You need to measure the sleeve bore and the outside diameter of the puck needs to have enough clearance to clear the block bore. You will need a puller similar to the one Keith made along with some 3/4 allthread & hex nuts. Hal

Looking for a Farmall H sleeve puller or puck

Yooper Farmall

Member

tractorsam

Well-known Member

El Toro

Well-known Member

Similar threads