Building a bigger H

Clint Skarovsky · Oct 7, 2010

Hi Guys, I've got an early H that I'm going through and building into a puller. While I'm in there I want to go with the largest reasonable bore I can get. I'm not opposed to boring the block but I need to speak to someone who's done it before and need to find a source for the pistons, etc. Any help is appreciated.

Thanks,
Clint

sflem849 · Oct 7, 2010

There has been a lot of talk about this in the last two weeks. Check out some of those, there is a TON of good info.

Allan in NE · Oct 7, 2010

Ya might try the pulling board.

Allan

Wardner · Oct 7, 2010

Go to the archives and enter "Jakee" and "ChadS". Lots of first hand info on modified IH engines, including the H.

Jakee's best stuff is eight years old or older.

ChadS will sell you whatever you need. He has also posted for years on the pulling board.

I hope you have alot of time and a healthy mouse finger. If you don't want to spend the time perusing the archives, just call Chad. Think he has a website too. I hope you have enough cubic money to pay for the cubic inches and the parts that may separate at high velocity from your H.

Charles E. McNelly · Oct 8, 2010

http://chadsantiqueperformance.bravehost.com/
hope this helps.
Charles

3500sport · Oct 10, 2010

Andrew Z also pulls with an H that has like 90 horse but looks stock.

Building a bigger H

Clint Skarovsky

Member

sflem849

Well-known Member

Allan in NE

Well-known Member

Wardner

Well-known Member

Charles E. McNelly

Member

3500sport

Member

Similar threads