Ron Zaccagnini
New User
Help. Im wanting to convert my 350 Industrial to 12 volts. There is a kit for the M, but..are they the same engine? Has anyone tried this using that kit? Without the kit? Thanks in advance.
- Thread starter Ron Zaccagnini
- Start date
Janicholson
Well-known Member
They are not the same, The 350 is a more powerful edition of an H engine. They are basically scale models of each other. The process is similar however. I recommend using a Hitachi alternator from a mid 1980s Nissan PU. These are the same wiring as a Delco 3 wire setup, not complex, and modest in size (better hood clearance) Bracketing is not a problem if you can handle som all thread and spacers. The wiring diagram (and tons of additional content)are in the archives. Bob M wiring diagrams are a main stay of this process. JimN
Ron Zaccagnini
New User
Thank you very much. I'll look at the archives. Have you done this conversion? how about the one wire alternators? The local parts house is pushing those. Thanks again
TractormanNC
Member
Don't like a one wire. Biggest complaints don't start charging at idle and sometimes cause excessive battery drain when not run for long periods. Myself, I like the three wire. not that much more complicated to wire. Cheeeper too. Diagrams in the archives.
Formerly PaMike
Member
Check out www.brillman.com. I got the small alternator, the wiring harness that plugs right in and the electronic ignition conversion for my 350U. I just got the stuff, didnt get it in yet. The harness is labeled where each wire goes. Its a nice setup.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy