Farmall H trans/rear end write up?

Faster346

Member
Just wondering if there was any sort of forum write up on tearing the trans and rear end apart on an H. Back in winter, my Farmall started making a weird noise coming from the Transmission area, and all of the sudden locked up while I was driving back up to the barn. I put it in Neutral, fired it back up, and let the clutch out, and it seemed to try to move, although it was still not in gear. So I put it in reverse, and backed it up until it did the same thing, so I put it in N again, and pushed it up to the garage, and just finally getting ready to tear it apart and see what the deal could be. I'm pretty knowledgeable when it comes to building cars, and messing with my drag cars, but I've never torn into the H aside from rebuilding the carb, and wondered if there was any diagrams or write ups. Thanks!

-Lance
 
I bought an H this winter that would not moove in gear cause the water had froze. We used a skidloader to load it on a trailer and back off. I let it sit till this spring and pulled the drail plug and drained about 4 gallons of water.
 
Possible intermediate (pilot) bearing between the input shaft, and output shaft in the trans. Not too bad. Top cover, Liftall, clutch shaft. JimN
 
I pulled the drain plug and NOTHING came about. I guess my uncle didn't keep up on the tractor like he should have. Stopped and got some fluid for it and filled it up, and fired it up and tried to move it, but it must be too late. It just makes a horrible noise while it runs, even in Neutral. Time to start tearing it apart so I can get the top cover off and see what's going on. Thanks for the help so far, I'll be needing A LOT of it!
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top