350 high utility wheel bearings

Bob21 Martin · Jan 21, 2022

?Are these replaced by taking the hydraulic reservoir off or can you get to them through the back PTO

Thanks for the help,

Bob

Janicholson · Jan 21, 2022

The axle bearings are in the axle housing The inside one is between the bull gear and the extension of the housing, sandwiched by #2 Support. The outer axle bearing is as shown out on the end of the axle behind the Cap Part 11. It really needs to come apart with the top off, and the Housing #4 removed. Jim
Diagram

DeltaRed · Jan 21, 2022

I really can't give you a good answer.But you really should buy a 40 dollar I&T service manual from this site,or your favorite farm store.Dont turn a wrench without reading first.

Bob21 Martin · Jan 22, 2022

All righty. That's what I needed to know, Jim

Thanks, Bob

D Slater · Jan 22, 2022

Yes you can remove the bolt and washer from inside end of axle through the PTO hole. Then easier to service inner bearing after axle and axle housing is removed. High utility is made like a Farmall with no outer flange on axle. Outer axle bearing comes out with axle then removed from axle. Inner bearing is retained in axle housing with 2 plates and 4 bolts. If axle is tight in bull gear splines a pusher bolt with sleeve can be placed between axles to push out. Or top can be removed from rear housing and axle housing left on tractor. Then remove axle and bull gear out and replace bearings. 4 bolt cap on end of axle lets axle be removed after inner bolt and washer is removed.

Bob21 Martin · Jan 22, 2022

Thanks D Slater. Looks like that's going to be a project before hay season comes around.
That's my raking mule.

Bob

350 high utility wheel bearings

Bob21 Martin

Member

Janicholson

Well-known Member

DeltaRed

Well-known Member

Bob21 Martin

Member

D Slater

Well-known Member

Bob21 Martin

Member

Similar threads