(800) 853-2651
SHOP NOW

1933 Farmall F12 Hood Sheet Dimensions

S

SadFarmall

Member
Some further information for hood sheet dimensions:

Stiffening ridge along centre of hoodsheet:
Length: 15.5"
Width at base: 0.8"
Height of Ridge: 0.325"

mvphoto61061.jpg

Total Length: 22 3/4"

mvphoto61058.jpg

Hole for Starting Tank Filler is: 3.497", basically 3.5"

mvphoto61059.jpg

From off side edge of hood sheet to edge of filler neck hole: 7 5/8"

mvphoto61060.jpg

From near side edge of hood sheet to edge of filler neck hole: 7"
SadFarmall
 
No, I have never seen one like it before either. The only pictures in the parts book for an early kerosene attachment like this are of the fuel lines and taps. They seem to match what is on the tractor. Unfortunately IHC did not see fit to print pictures of the tank or hood sheet, though part numbers are given. So far as I can guess, it is all correct factory fit. So far as I am aware, all F-12 tractors sold in Australia were setup for kerosene except for a very few sent here with Waukesha engines.
SadFarmall
 
I just sent you a reply asking where your from.Now Im reading this.I dont know where my parts book is right now.I would love to have a hood and tank
like that
 
I am in Victoria, Australia. I am getting the tank repaired as the bottom of it has a rather interesting lacework effect due to rust. The only part of the tank, which is complex is the base. The tank is made in four parts: flat top, filler neck, sides and base. All silver soldered together. The outlet pipe is riveted and soldered to the base. I wonder if I can get a copy made? Hard to find good sheet metal workers nowadays.
SadFarmall
 
You must log in or register to reply here.

Similar threads

R
1933 starting tank hood dimensions
Replies
7
Views
294
SadFarmall
S
S
Kerosene Farmall F12 Cylinder Head Removal Guide
Replies
3
Views
675
SadFarmall
S
J
Fuel tank comparison
Replies
8
Views
2K
Jim.UT
J
S
Plow setup
Replies
8
Views
3K
John M
John M
D
My 1941 Case VC tractor (long and photos)
Replies
3
Views
1K
Bruce Reimer
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top