(800) 853-2651
SHOP NOW

Super C pto oil seal and bearing replacement

M

mu2

New User
Hi,
I could use some direction in removing the pto oil seal and replacing the bearings on the pto shaft in a Super C. I'm not sure how to
remove the housing around the shaft - is it just the bearing holding it in place?
Here is a picture - I removed the lower bolts after the picture was taken.
Thanks,
Mike
cvphoto21035.jpg
 
I'm having trouble removing that casting. Does the upper gear and the bolts surrounding it need to come off?
I've been able to create a small gap between the back of the casting and the tractor body but that's about it. Could the outer bearing be holding it in place - how do I remove that outer bearing?
Thanks
 
The entire PTO and belt pulley unit will come off the back of the Farmall C series tractor as a unit. It's just held on with some bolts and a couple dowel pins.
mvphoto35264.jpg
 
Thanks for the photo.
Did you use some kind of puller to remove it? I was thinking of wooden wedges around the outside
of the housing.
I have a gap of about 1/8" now but didn't want to force anything until I knew how it came off.

Mike
 
Pull it straight out. Careful it's heavy. Do make sure the poppet don't pop out. Mine did and had to make a new one.
 
You must log in or register to reply here.

Similar threads

C
Super C input shaft seal replacement
Replies
1
Views
99
Charlie M
C
R
Super C clutch pilot bearing
Replies
7
Views
323
Roger46
R
U
960 PTO Seal Replacement
Replies
1
Views
114
TomIn
T
M
Control Tower Differences - Super C
Replies
2
Views
233
mainer76
M
D
bull pinion bearing replacement
Replies
8
Views
295
DD in WA
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top