Farmall M Governor Rebuild

Trent Couch · Oct 20, 2018

I have gotten this far tearing into the Governor and I can?t seem to figure out the best way to remove the front bearing what is the best way to get this the rest of the way apart?

Duane Rushlo · Oct 20, 2018

just push complete weights and shaft out the front of houseing

the tractor vet · Oct 21, 2018

Just bump the housing on a wide open vice and it will fall out , I see things that need addressed here that you do not see , the arm with the spring is the bushing is GONE like 98% of them are along as the one in the arm going to the throttle linklage . The org ones were made of a hardened steel and were not pressed in tight enough and MOST have fallen out over the years . This causes the spring to fit in sloppy and causes the gov to not work as it should . when i do a rebuild on them i make up bearing bronze bushing and PRESS them in but one has to be vary careful as not to break the castings . The hole in the bushing needs to be about .005 over sized of the spring wire and both sides of the hole need to be champhered due to the curve of the spring . The spring must be tight some what but with no binding .

Farmall M Governor Rebuild

Trent Couch

Member

Duane Rushlo

Member

the tractor vet

Well-known Member

Similar threads