Addamsonflint
New User
Hey everyone! New to the board.
I have a JD 350C, and I have been scouring the Earth the past 2 years for a Drott 4-in-1 for my machine, with not much luck thus far.
I just found a 2010 on Craigslist with a 4-in-1, along with a 51 backhoe.
That said, a couple quick questions:
1) Do the holes and centers line up on a 350 from either a 1010 or 2010?
2) What about a a bucket from a 450 on a 350?
3) If they don't line up on either, how much fab-work would I have in the swap?
4) Regarding width, can I run a slightly wider bucket on my 350 instead of it's standard 60"? Could I get away with at least a 72", maybe even an 80"?
(I do have single-grousers, in case that matters. Naturally, it's more stress on the drives of course)
5) Lastly, I have a 9300 hoe on my 350C. Any parts worth having from that 51 backhoe that is on this 2010?
Any input would be appreciated, and thanks for reading.
I have a JD 350C, and I have been scouring the Earth the past 2 years for a Drott 4-in-1 for my machine, with not much luck thus far.
I just found a 2010 on Craigslist with a 4-in-1, along with a 51 backhoe.
That said, a couple quick questions:
1) Do the holes and centers line up on a 350 from either a 1010 or 2010?
2) What about a a bucket from a 450 on a 350?
3) If they don't line up on either, how much fab-work would I have in the swap?
4) Regarding width, can I run a slightly wider bucket on my 350 instead of it's standard 60"? Could I get away with at least a 72", maybe even an 80"?
(I do have single-grousers, in case that matters. Naturally, it's more stress on the drives of course)
5) Lastly, I have a 9300 hoe on my 350C. Any parts worth having from that 51 backhoe that is on this 2010?
Any input would be appreciated, and thanks for reading.