(800) 853-2651
SHOP NOW

I have been through my DCManuals

chuck machinist

chuck machinist

Well-known Member
Manuals Can’t seem to find the physical length front of
radiator to end up drawbar length of a DC -4 Getting ready to
load one in a couple of weeks with a plow. Would like to load
it well balanced on a 20 foot PjTrailer , With a three bottom
centennial case plow. I hope this post finds all in good health
CM
 
Length of the tractor does not tell you a thing. Hook up your trailer and measure the rear bumper from the ground. Drive the tractor ahead on the trailer till the rear bumper is 1 1/2" lower than it was unloaded. With a 1 ton dually like mine your tractor will be all the way to the front and that is just fine!
 
You must log in or register to reply here.

Similar threads

chuck machinist
Sharpening my skills with the HVLP gun
Replies
4
Views
230
chuck machinist
chuck machinist
D
Feel like I have been taken advantage of.
2
Replies
31
Views
2K
45cole
4
K
Plowing With Ole Ollie
Replies
2
Views
557
scootergmc
S
chuck machinist
Helping out the landlord
Replies
7
Views
746
comfortking
C
E
Plowing field with 8N - Need assistance
Replies
18
Views
3K
Ed S.
Ed S.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top