Need to move non running 1840 loader

RGMartin

Well-known Member
Bought a nice low hour but non running 1840 uniloader (no oil in it, suspect based on where it was at auction and other evidence that the auctioneer tried to use it to set up for the auction without checking that the engine oil had been drained).

I need to winch it onto a trailer tomorrow, are there hydro relief valves that will allow it to coast? Where are they?

My winch might dead drag it, but I would rather not?
 
FWIW, in CASE this helps anyone else, there are 2 hex headed valves on the side of the drive pump assembly with cross drilled heads that take a 5/8" wrench. A couple turns let her roll.
 
Glad you found them. If I had seen this
post earlier I was going to say it's
similar to zero turn mowers to release the
drive units, but sounds like you found
them.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top