Iím guessing it has a torque tube forward of the transmission. If so, there should be a square headed plug on the left side of the torque tube that is the fill hole. This would require a hy-Tran type fluid. Jim
Re: 1963 Case G430 New Owner in reply to flatpkr, 07-17-2019 18:13:27
Is this the torque tube? It's underneath the gauge cluster and it has pipe coming from the 3 point. But I see no square screw plug. I posted the left side of this above that has a hydraulic hose going to it. But also see no square plug.
Re: 1963 Case G430 New Owner in reply to HermannFelix, 07-17-2019 20:18:14
The torque tube is the section of the transmission case between the clutch housing and the rear end. Allis came up with the patent on it. It is my understanding Case had to pay Allis 50 cents for every tractor they made that had one. Your tractor is different than mine, but it looks like there is a plug below that lever on the left side of the tractor in one of the first photos. My tractor (351)has a plug that takes a 1/2 drive but it looks like you have that switch with wires coming out of that hole.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.