Well Tom, Pastor John and I have determined that there is a 75% chance that Winterset Ia. will host the 2015 Who tractor ride in June .Care to weigh in? Our second guess is The Amana Colony. Chuck Machinist
Re: Tom Turkey WHO 2015 in reply to Mark-IA, 01-08-2015 17:18:19
Mark- Your source was correct, Ames Ia. is the central point. We will start out each day and renevouse Sunday at the Farm Expo Site. BTW Pastor John and Brother Chuck, the giant pecan cinnamon role was delious as was the milk and coffee. gobble
Re: Tom Turkey WHO 2015 in reply to Chuck Machinist, 01-08-2015 14:23:43
It would be Great if it would be in Winterset. Of course I don't think there is a snowmans chance in July that it is an adequate city to host such an outstanding event. But we will see tomorrow, Chuck if you come to the machine shed restaurant for the announcement, I'll buy your breakfast. I would buy yours also Pastor. But I'll be there and we will see. blessings tom aka gobble
Re: Tom Turkey WHO 2015 in reply to tomturkey, 01-08-2015 15:02:51
Ill be about 15 days too late for the breakfast Hee! The year that I retire ,Ill take you up on that. Sounds like they want to lean towards the way they used to arrange tractor rides. Simpler times. Not a bad idea hey?
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
combine ih 303 403 101 151 503 615 with grain plat header control
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.