|
| |
| Case Tractors Discussion Forum |
Red Power Roundup
| Author |
[Modern View] |
|
Straw Boss
06-24-2014 00:30:10
|
The Red Power Roundup in Huron, SD is only an hour from me. Just wanted to mention that if there's anybody here with an IH itch to scratch, I have a Regular and an F-20 for sale or trade.
Both are old restorations and I consider them to be parts tractors but they could be restored again. Both are on fair rubber and are complete.
I would take CASE implements or collectibles in trade. Of course cash is always good too. Ha!
I'm just curious to know if there's any interest beings so many folks will be passing right by em.
|
|
|
|
|
C. Amick
06-25-2014 09:30:49
|
|
Re: Red Power Roundup in reply to Straw Boss, 06-24-2014 00:30:10
|
|
| |
If you could put them out along the road where the Red Power roundup attendees could see them as they drive by, you might find a buyer.
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
combine ih 303 403 101 151 503 615 with grain plat header control
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
