|
| |
| Case Tractors Discussion Forum |
just a simple seal change! vac
| Author |
[Modern View] |
|
steven in tn
04-21-2013 17:21:21
|
that is what i was hoping. got everything broke down and noticed i had a bad bearing. got that ordered and noticed i had 2 chips broke off the bull gear, not bad but i happen to have a good spare.
since im this deep into it, gona replace all 4 bearings on the shafts, new seals and gaskets,
and replace bull gear.
found everything at local parts house
except 3822 rb race.
any idea where to find one. looks like it has a grove around it for a sirclip. is this right?
for a 51 vac. thanks guys
|
|
|
|
|
mattwillson
04-21-2013 17:52:14
|
|
Re: just a simple seal change! vac in reply to steven in tn, 04-21-2013 17:21:21
|
|
| |
Hi Steve, I m waiting for the same bearing. I ended up going all Timken, mostly because they re the only ones that apparently can get that 1 part and by marking out to the rep about keeping it original helped alot too. Napa or most auto part stores won t be able to score this stuff, a heavy truck parts joint can though and the prices are lower as well.
|
|
|
|
steven in tn
04-23-2013 12:43:56
|
|
Re: just a simple seal change! vac in reply to mattwillson, 04-21-2013 17:52:14
|
|
| |
where did u find the 3822-rb at and how much was it? only one place near me can get it and its $285.
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
combine ih 303 403 101 151 503 615 with grain plat header control
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
