| |
Case Tractors Discussion Forum |
Loren nice plow
[Show Entire Topic]
Author |
[Modern View] |
4435
12-06-2012 10:28:11
|
About the only thing we plow here in SE Kansas are terraces. I have some snaky ones' with some right angle turns. Will this make the turn? Hence few rocks to contend with. But a spring or hydraulic reset would be awesome. My JTA turns pretty nice but you can't get back to the fence line. The lever set up on yours is very nice. Although you cannot see it, the right side of the draft bar pivot slot has been torched out to allow greater pivoting.
Tom
|
|
|
Adirondack case guy
12-06-2012 14:54:00
|
Re: Loren nice plow in reply to 4435, 12-06-2012 10:28:11
|
|
4435, The setup I have will never work for you. Perhaps that is why the part is missing. There is still some debate left as th the prefix of this plow, but the last two didgits are 46, but first two might be MS??? There is a posability that the cast spring holders are all broken off, and don't show. Could you post a pic from the rear showing the top of the beams, if it is not a shearbolt shank plow. I'm not quite sure. Loren
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Needing good 70 series fenders. No rust or dents preferred.
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|