|
| |
| Case Tractors Discussion Forum |
vac
| Author |
[Modern View] |
|
Donald Van Wyk
12-23-2010 06:33:38
|
Vac leaks around axles .How do fix thisw?
|
|
|
|
j heitkemper
12-24-2010 19:31:12
|
|
Re: vac in reply to Donald Van Wyk, 12-23-2010 06:33:38
|
|
| |
You could try LUCAS hub seal 1st ,, NAPA should have it
|
|
|
|
C. Amick
12-23-2010 11:40:44
|
|
Re: vac in reply to Donald Van Wyk, 12-23-2010 06:33:38
|
|
| |
First check your transmission oil level to make sure it's not too full. There could be water in the bottom of the transmisssion that would raise the oil level. If you want to first try a chemical solution to the problem, I think Lucas makes a hub sealer that can be added to the oil. New seals is the other solution.
|
|
|
|
1031D
12-23-2010 08:06:52
|
|
Re: vac in reply to Donald Van Wyk, 12-23-2010 06:33:38
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
Rebuilt 1979 Ford Truck Rockwell Rear axle. This axle will also work as the rear axle in a tandem set up. This is out of my F700 and is a single speed. Rockwell with 6 hole wheel lugs.
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
