|
| |
| Case Tractors Discussion Forum |
vac clutch
| Author |
[Modern View] |
|
carl Schreiner
07-31-2010 09:20:44
|
One day clutch was fine, next day wouldn't release. Split tractor, throw out bearing shot so replaced. Pressure plate looked fine. rebolted tractor...still no release on clutch. can I adjust clutch or at least test clutch springs when I split tractor again? not sure what to do next. thanks, carl
|
|
|
|
C. Amick
07-31-2010 18:55:46
|
|
Re: vac clutch in reply to carl Schreiner, 07-31-2010 09:20:44
|
|
| |
Is it a new clutch plate? Could the lining be too thick? If it is the old clutch plate, the release rod is probably worn.
|
|
|
|
carl Schreiner
08-01-2010 10:02:31
|
|
Re: vac clutch in reply to C. Amick, 07-31-2010 18:55:46
|
|
| |
thanks for the reply. The clutch plate is not new, but pressure plate is not worn out. Is the release rod the same as the release lever? can it be adjusted? can I test the clutch after spitting the tractor but leaving clutch in place? thanks, carl.
|
|
|
|
C. Amick
08-02-2010 13:20:49
|
|
Re: vac clutch in reply to carl Schreiner, 08-01-2010 10:02:31
|
|
| |
I had a new clutch plate that wouldn't release and I adjusted the length of the rod until the clutch pedal hit the tractor housing when depressed. Are you to that point?
|
|
|
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
... [Read Article]
Latest Ad:
John Deere wheels rare pair of A1106R 24 inch solid cast rear wheels 3000.00. Pair of BWH / BNH 40 inch spokes 1600.00 pair of John Deere D front spokes 350.00.
[More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
