1190 case bent pto shaft

Jason in TX · May 13, 2009

I am looking at an 1190 case a friend has for sale. It has a bent pto shaft from the driveline breaking loose on a shredder.

How hard are they to pull and replace, do you have to split the tractor, or does it just pull out from the rear with a retainer ring?

How much does a replacement shaft cost?

casestudy · May 14, 2009

ithink you better to take off the pto housing before you do drain the oil and take off the small hyd vacuum filter switch underneath the housing two 7/16" bolts and take off as much weight off it as possible, you will have to take off the cover with the 4 3/4" nuts workshop manual says to drive pto shaft backwards there is a split ring in front of the rearmost gear should be straight forward from there, when you are putting back the pto housing on the tractor i use two guide bolts makes it a bit easier,it's a bit longwinded but hope this helps you.

1190 case bent pto shaft

Jason in TX

Member

casestudy

Member

Similar threads