(800) 853-2651
SHOP NOW

510b needs a new crank

R

rdrash

Member
Hi I have kind of hit a dead end with this 510b. I bought it for dirt cheep knowing it had a bad knock and started tearing it a part the other day. Today I found out the no 1 jornal is 50 thou out. So im wondering what are my options? Are there new cranks around, or what other engines would fit? 510b's seem to be very rear around here, "Alberta canada". I thought they were dry sleaves but this is a wet sleave. would a 188cu or 159 case engines fit without much changes. This is a great little tactor and I would like to see it runnig again and can really use it around here. A tractor like that with a loader and running good can go for $4000 or more around here so I don't mind throwing some money into it. Thanks for any help you can give me
 
I do have a complete engine for 511 B if you do not find anything else but the freight might be an issue since I am from Ontario canada and you are from alberta. Also if you find a Case engine G159 or G148 out of 430 or 530 tractor or backhoe the crankshaft G11183 is the very same thing . good luck jc
 
I would look into what engine you actually have. Check the bore and the crank# and maybe you can find what you have.
 
Thanks every one for all your advice. I did not know u could weld on a crank to build it up. This is my only second engine I rebuilt, so bare with me. It could be the wrong engine on that tractor, Ill get the numbers off the block today. I read that case built a 164cu wet sleeve engine after they quit building the tractor as a replacement. I noticed yesterdaty the engine I have does not have the side cover on it, like the one in the parts manual, so Im not sure what engine it has. Im sure the tractor is a 510b. Thanks for the help
 
I just got back with some numbers, the crank is # g11709, which matches up with my parts manual for a 510b. the only thing I got off the engine was cwc h310 and the serial number 345tc1140.
 
You must log in or register to reply here.

Similar threads

W
424 IH needs new hydraulic pump
Replies
8
Views
290
wwoodrow
W
Griffithms
New to me Ford 907 flail mower - NEEDS WORK!
Replies
4
Views
365
BarnyardEngineering
BarnyardEngineering
S
Old 350d c series injection pump crank no start.
Replies
0
Views
153
Scotty2track
S
B
Crank Driven Hydraulic Pump Oil
Replies
3
Views
475
Bill VA
B
P
Kuhn Versus New Holland
Replies
2
Views
409
Buck2A
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top