| |
Re: Clutch pedal is loose
[Show Entire Topic]
Author |
|
Craig MO
07-11-2002 17:58:35
|
Take the pedal and have it bored out and a bushing put in. Pull the shaft out and have it built up and turned down and it will be like new.
|
|
|
john
07-11-2002 20:06:58
|
Re: Re: Clutch pedal is loose in reply to Craig MO, 07-11-2002 17:58:35
|
|
The tractor is a d17. That shaft you are talking about, it doesn't go through into the transmission does it? What would you use to pull the shaft? thanks
|
|
|
david l wilson
07-15-2002 21:54:25
|
Re: Re: Re: Clutch pedal is loose in reply to john, 07-11-2002 20:06:58
|
|
the shaft you are talking about does go into the hand clutch housing,i had a heck of a time getting mine out ,used pipe wrench,vice gripps and a hammer, but i finally got it . i bought a new one from agco for about $ 30.00 .be careful if you do this as the detent ball for the pto shifter is on the inside of this shaft and will fall into the bottem of housing when you pull the shaft.then you get to split tractor to fix the screw up [ expiriance talking] but not too bad a job. i had my pedal bored and a bushing installed, works great now. good luck. david l wilson i2bzy@hotmail.com
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
16 x 38 double bevel rims, sealed and painted 250 each
[More Ads]
Copyright © 1997-2022 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|