(800) 853-2651
SHOP NOW

Allis chalmers sickle mower question

A

AdamEichele

Member
Question regarding allis chalmers mower heads, I am familiar with New Holland, International etc. Was there any set backs to the Allis Chalmers heads? I have seen pictures and videos. Also what was the knife speed. For instance the new Holland are rated at 1600 strokes per minute the international were at about 2000. Was the allis concept good and worth getting. Help is appreciated--Adam
 
The ac heads are grooved and fit into a matching
grooved piece on the twin wheel drive. No clue on
speed. That are ok mowers but just ok
 
If you are talking about the later model Twin Wheel Drive models I don't know the exact speed but they'll cut as well or better than any sickle bar ever built.They did have several issues
with the bearings in rear of the arms being the worst,all bolts needed to be kept tight as they tended to vibrate loose.I used the different AC Twin Wheel Drive models for years but have now switched to New Holland as parts are easy to come by for the New Holland and not very available for the AC.Also the AC mowers needed to have a very sharp sickle at all times to minimize wear and tear of course that's really true of any sickle bar mower.
 
You must log in or register to reply here.

Similar threads

E
Allis Chalmers B carburetor question
Replies
13
Views
4K
Bergmann
B
D
Allis Chalmers ib with rotary mower?
Replies
2
Views
748
old
O
S
Drum Mower question
Replies
15
Views
636
Destroked 450
Destroked 450
S
IH sickle bar mower again
Replies
15
Views
508
johndeere720GA
J
B
Best Pull Type Sickle Mower
2
Replies
23
Views
2K
Bill VA
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top