Re: allis c engine swap in reply to allis fields, 10-06-2014 21:51:11
About four hours if you have everything ready. Plan on taking a day. You will have to use the clutch assembly and will need four step studs from 5/8" standard thread down to 1/2" fine thread to bolt the front casting to the block. The CA used the step studs. Some hole changing in the hood.
Re: allis c engine swap in reply to Dick L, 10-09-2014 14:22:17
You also need to use the C fan.
On the hood, you need to move the muffler hole, the oil fill hole and the C air filter will not fit. You can drill out the radiator mount to a size to fit the D14 studs if you don't have the step studs.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.