I have a 1945 Allis Chalmers grader tractor. My rear wheel rims are rusted out. The tires that run on the rims are a 12.00x24. So the rims are a 24 inch. Are there any rims out here that I could purchase. Thanks Jim
Re: rims in reply to Jim Marmon, 07-24-2014 11:47:19
I only have this one parts manual and I got it a few years back from some one on here but it is the only one I have and I do not know where to find another one. I can scan pages from it but that is about all. By the way does your look like this?? I own this one and use it. Mine is a 1947
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.