I am restoring an RC. I think it has original paint. My question is, when I was getting ready to sandblast the front rims, I noticed two, can't tell if they are blue or black, stipes around the rim. One on the first and second ledge from the tire. Would this have been factory? Thanks
Re: RC front rims in reply to kenl, 07-02-2013 10:21:34
Our RC had these pin striped rims as did our similar vintage 1941 WC. Just finished a very correct restoration of the RC and had a local automotive pinstripe artist apply the proper dual black pinstripes. Kip
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.