(800) 853-2651
SHOP NOW

Allis G questions

D

David R Inman

Member
Hi. Our G is a 48 and it has a vertical gas tank, with an opening in the flat top for gas input, but this is not seen in any of the book I have. So I'm guessing this is a PO modification?

I assume no fenders means ours have been taken off rusted out or for a different tractor?

Also we have 3 stets of fount spindles of two different vertical lengths. Any comment on this?

Sorry no pictures, but the tractor is in the shade and therefore not enough light to photograph.
 
gas tank must be a custom set up if it is different from what the manuals show.

i dont think that there were any stock spindles that were different but i am not an expert by any means.

fenders mount to the gas tank. if you have a different gas tank the original fenders may still be with the original tank
 
Thanks. I think the gas tank is the original, but has been modified to allow an after market hyd. pump instantiation.
a114913.jpg

a114914.jpg
 
the tank is the original, but turned up and re- engineered. Allis only used one spindle height, but many modifications have been performed over the last 60 odd years!

Mounting some fenders is going to take some custom bracket work as the fuel tank and it's mount were used. Shoot me your email, I have some manuals that might help on this project
Joe

<a href="http://s33.photobucket.com/user/Joecdeere/media/tech%20pic/P1010038_zps91d6c63b.jpg.html" target="_blank">
P1010038_zps91d6c63b.jpg" border="0" alt=" photo P1010038_zps91d6c63b.jpg"
</a>
 
Thanks Joe. I all ready got the manuals from you, and was just making sure as to some of the oddities we found with ours (after I posted I realized the re-engr). There neat little tractors, but there mighty different from the WC-WD-WD45 series we are familiar with.

We'll probably forget about the fenders, and use the gas tank as is. Now if we can just find the time to work on it!
 
You must log in or register to reply here.

Similar threads

A
Allis Chalmers D14
Replies
2
Views
475
AllisD14
A
J
Allis Chalmers tractor jeep parts
Replies
6
Views
884
mdm1
mdm1
mdm1
Allis G no start.
Replies
5
Views
542
13fx
1
A
Allis Chalmers D14
Replies
10
Views
624
Jim.ME
J
M
G rough running questions
Replies
4
Views
390
Leroy
L
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top