Gregory K Soderberg
New User
Does anyone know where I can find a schematic on line showing how a radiator is mounted into a WD45?
- Thread starter Gregory K Soderberg
- Start date
You don"t need a schematic- there are two half inch bolts under the radiator, in the C-channel frame- need a 3/4 inch socket to loosen them. There are tapered washers that are on the bolts, the taper matches the angle of the C-channel, so the head of the bolt fits flat against the washer.
Aaron SEIA
Well-known Member
http://www.agcopartsbooks.com/PARTSBOOKSN/Viewer/book.aspx?book=agco/79001544
There are holes in the bottom of the frame rail. I have learned that a long 3/8 extension will fit in them. Put the extension through the lower hole, then put the 3/4" socket on. Make taking them out so much easier. Might have to turn the wheels on a narrow front for room. As others have said, should be a lock washer and the wedge under them. The rad bolts also hold the bottom of the sheet metal front.
AaronSEIA
There are holes in the bottom of the frame rail. I have learned that a long 3/8 extension will fit in them. Put the extension through the lower hole, then put the 3/4" socket on. Make taking them out so much easier. Might have to turn the wheels on a narrow front for room. As others have said, should be a lock washer and the wedge under them. The rad bolts also hold the bottom of the sheet metal front.
AaronSEIA
Gregory K Soderberg
New User
Thank you Aaron, JMS/.MN & big jt! I'll give it a shot! Greg
Brian G. NY
Well-known Member
I figured that out also; makes the job much easier!
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy