doublemfarm1
New User
Hello everyone. I am looking for advice. I have an oil leak from both the right and left-side draft control arms. Looking at my service manual, it looks like I might be able to drive the shaft to the left, then to the right to psuh out the bushing on both sides, without actually removing the shaft. But I think that when I do this, the shaft splines will come out of the torque arm. Has anyone replaced the lip seal and o-ring in the bushing by doing this? And how hard was it to get the splined shaft aligned and back into the torque arm? Any advice on changing these seals would be appreciated. I just got the tractor (2100 hours), and this is the only leak on it. Thanks.
