Re: Finish mower in reply to baw, 06-03-2009 05:32:06
I run a 6' land pride behind mine runs it just fine, won't pick it up though. It comes up about a foot them the front end comes up and the mower settles back down on the ground. I put two of the weights that mount to the side of the engine on it, I think they are 90# apeice and three oliver front wheel weights mounted to a homemade bracket on the front axle. I don't know what those weighed. The front end stayed on the ground but still got pretty light. Plenty of power for it though. Good luck, Mike
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.