Re: head rebuilding in reply to caseFrank, 05-26-2009 15:46:32
If they have to put in new seats make sure you tell them that the new automotive narrow seat will sure enough give a great seal but unless they put in the automotive valves it does not take long for the seat to pound deep into the valve head. I had pictures somewhere that showed that when the deep ring was removed from the valve that the valve could not be used after ground one time. New valves to match the new hard seats are real spendy and will not be cataloged for the tractor head. I use the cast iron seats but have to watch to buy new old stock.
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.