Return to List
|Restoring a 1931 Model D John Deere|
I am currently working on a 1931 model D John Deere. I purchaced two of them, one for parts, boy am I glad I did that. The problem is after examining them to determine which one to work with I chose the wrong one, thus creating a lot of extra work for me.
The head was cracked, the parts tractors head was not. The rods and mains were worn beond use but the parts tractor had been bored in the past and I could not use the piston from it. So the local machine shop came in handy. He mad new wrist pins, rebabbited the rod and main bearings and refitted them. The crank was turned. I had to take it over 100 miles to be done because it is 7 inch stroke and every one closer that did that work only went to 6 1/2 stroke.
I disasembled the radiator and repaired the cracks in the castiron with nickel welding rods. I rebuilt the brass carb with a kit bought from NAPA auto parts store. The govoner weights were worn so I got the ones from the parts tractor and put in new pivot pins. I bought a gasket set from JD and put engine back together.
I got the oportunity to go to a plowing party after the engine was reassembled. This was very helpful in finding out were all the leaks were so they would not ruin my future paint job. After ironing out an idle problem, that turned out to be an idle curcuit that was pluged, it was ready to be disassembled and sandblasted and painted.
At this time I am almost done painting the tractor except for the fenders which will be a spring project. It's first show without fenders will be Sept. 6 and 7 at Eagleville TN. Hope to see some people that surf the antique tractor web there. Happy Tractoring Bryan West
Bryan West, entered 2000-02-16
My Email Address: Not Displayed
Return to List
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
444 diesel Massey Harris
| Copyright © 1997-2023 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy