| |
Return to List
Younger Brother and the Farmall C | It was around 1974 I was 17 my younger brother was about 13. He could handle a tractor pretty good for his age. We had a Farmall C at the time but the starter went out the day befor and was in the shop getting repaired my brother was going to start disking the the field where we were going to plant corn. We parked the C at the top of a hill beside the barn over looking the plowed field so we could coast start it sence the starter was out. So I told my brother to put it in second gear push in the clutch turn on the ignition and release the brake let it get up a little speed and release the clutch all at once and it will start right up with no problem. Well he didnt do exactly as I told him he started down the hill before he got it in gear by then it wouldnt go in gear it just raked real bad. He wasnt quite strong enough to hold the brake peddle down hard enough to slow himself down he couldnt make the corner at the bottom of the hill and struck a large end post and broke the narrow front out from under the C luckily he walked away without a scratch about that time dad pulled up with the new starter and ill never forget the look on his face. RICK, OH, entered 2004-02-03 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
444 diesel Massey Harris
[More Ads]
Copyright © 1997-2023 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|