Posted by NickatKY on May 01, 2013 at 09:21:06 from (98.93.216.74):
Michael
I finally had a chance to get the depth stop info for you.
Material List
Flat bar 5/8" x 2" x 18" you may want to cut it a little longer so you won't have to be so accurate making the bend. The hole for the crank assembly is 2 3/4 on center. This bar needs to be longer than the original. For some reason the originals are not long enough to line up with the lift yoke. I would wait until I had the assembly done then mark the holes in the torque tube.
Approximately 1" ID tubing 1 3/4 " long for above bar.
1 1/2" square stock 4" long to be turned down to 1" for 2 1/2" to fit into above tubing.
3/4" round stock 10" long for crank. Threads are course.
3/4" round stock 9 1/2 or 11 1/2" long depending on how you are going to make the end that attaches to the yoke.
Approximately 3/4" ID tubing 8 1/2" long for above rod.
The camera angle make reading the tape a little hard so I included measurements for you.Sorry it took me so long, but it took a little time to put this together. If you have any questions please post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.