Posted by Jim Cancil on December 03, 2012 at 05:33:07 from (67.162.230.233):
I have a pasture that has not been touched other than cutting weeds for 15yrs. It"s loaded with honey suckle vine, gums and maples, etc...
I want to plow this mess under. I mowed it close and put a old plow I have had for a long time on the back of my JD-1070. I got about twenty feet - then the plow lifted because it was jammed up with a mess that looked like a backlash on an old casting reel. I"d undo the mess and get another mess .. about 20" later. Maybe you can look at the plow and tell me if the cutters in front of the moldboards are too far away? ..it seems that is where the buildup begins.
I tried different depths .. played with the fore/aft tilt a bit .. but did not get that "flipping pages in book" I was hoping for. Maybe you folks have a suggestion for me. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.