Posted by donjr on October 04, 2012 at 11:23:12 from (220.127.116.11):
In Reply to: picking corn posted by LorenMN on October 04, 2012 at 08:03:37:
NI's are known for some butt shelling. And with the #7 and 10 pickers, you might want to look at your husking bed. The husking rolls should have a bunch of little nubs that grab the husk and pull it thru the rolls. They usually break or fall out with age. You may find them at an older dealer, but chances are slim to none. I had one, and solved some of the husking problem by welding some bead on the husking rolls in the area where the nubs had been. If the rolls are not pulling stalks through, again roughen them with aome welding beads to make them grab the stalks better. Hope this helps.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.