Tractor Talk Discussion Board |
Re: anyone running a sawmill off a tractor?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill in Ohio on July 11, 2004 at 07:22:31 from (64.12.117.10):
In Reply to: anyone running a sawmill off a tractor? posted by steve on July 10, 2004 at 19:50:14:
We have a Belsaw mill that we demonstrate at several shows in SW Ohio. It is using a 46 inch blade and I have put non functional teeth in half the sockets and it does a lot better job with basically whatever tactor that volunteers to pull it. The theory of tooth operation is that each tooth requires so much horsepower, whether it is just skinning the wood or cutting up to the point of filling the gullet with chips as it goes throught he log, so you either speed up the travel, or reduce teeth. It works for me, plus, teeth stay sharp longer and its half the effort to file them and half price to replace them! Bigger chips are easier to handle and you have less fine dust floating around, too. At home, I power it with a PTO on a little 1520 John Deere and it does good. I have a rope over to the throttle so you open it up on the cut and let it idle while you are setting up. The worst problems I have at shows is generally slow speed issues and unresponsive governors. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|