I agree with John T and others. If it trips when disconnected on the load end it will need to be replaced. Were it mine, I would dig it up in the center of its length (less digging than all the way) and use an amprobe meter on the wires If it shows current when the breaker is on, the short is farther, if none, it is nearer the house. Repeat to find the short. (an amprobe needs to be placed on one wire only IIRC) I also think 250 feet is too long for 10 gauge wire on 1 hp load. Jim
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.