Posted by AllisG on January 19, 2013 at 09:23:23 from (67.238.113.84):
Went out and bought a plow yesterday from a couple guys from my school that try and be country as possible,(talk, dress, walk, ect) these 2 told me they had a tractor tiller to sell or scrap. I go out there and its a dearborn 2 bottom and if i dont buy it they would SCRAP IT!!! I bought it and he went and got one of his dads tractors to pick it up. he comes back riding the clutch with it throttled as high as possible. After 3 tries he gets it backed up to the plow he asks how to hook it up, i said the 3 point he says Whats that? then i have to show him how to lower it. after its all hooked up he gets it half lifed up and goes full throttle tries to rip it out of the ground, he managed to rip the back coulter off the plow. i ended up 120 for it. He goes on to try and sell this rod thingy(pto shaft) this big metal thing(backblade) and a nice 5ft ford mower that in his words is ruined.
TO my point no matter how many pairs of boots you wear, cans of chew you do, and big trucks you drive it wont make you true country.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.