A "landscape style ramp" is kind of vague but the ones I usually see look too light for a full size tractor in my opinion. Here is my story:
I had a trailer built several years ago with two regular spring loaded ramps. I had a third ramp added and fixed them so they all stood up and didn't use up space on the beaver tail. This worked OK but I got tired of lifting and lowering ramps as well as shoving them back and forth adjusting the width for different tractors and etc. So, I welded in a center section between the two out side ramps and made them one full width ramp. I then hooked up a small hydraulic pump and cylinder to raise and lower it. It is safer as I don't have to worry about lining up the wheels with a ramp and my back really appreciates not having to wrestle these things. I have used this set up for two years now and it works like a champ.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.